Ali Dadkhah Tehrani; Reza Shirinabadi
Abstract
The soil's physical and mechanical properties are obtained through laboratory or in-situ tests. The dilatometer is an in-situ tool in rock mechanics and geotechnical engineering, and is widely used in developed countries. In the advanced version of this device, a geophone receives ground vibration. Thus ...
Read More
The soil's physical and mechanical properties are obtained through laboratory or in-situ tests. The dilatometer is an in-situ tool in rock mechanics and geotechnical engineering, and is widely used in developed countries. In the advanced version of this device, a geophone receives ground vibration. Thus Vs [1] could be obtained at the depth of the blade. This research work investigates the feasibility and performance of the first electronic seismic sensor due to its lower cost, more life span, more sensitivity instead of the geophone, and the ability to transfer signal. These changes make it an online tool connected to Arduino[2], a platform so the digital or analog result could be transferred automatically. The test is carried out under construction of Bahar Shiraz station of Tehran Metro Line 6 at the depth of 30 m. The hammer generates a shear wave, and after amplification, the received signals are measured with the software. The shear wave velocity at the test site is obtained at 504 m/s. The result compared to Vs reported geotechnical investigation done by “Darya-Khak-Pey consulting engineers” for Metro line 6 shows a 10% deviation. It is suggested to conduct more comparative tests to check the results and calibrate. Using an 801-S sensor with more life span (of more than 60 million times) and the ability to connect to the internet with an Arduino board is the innovation applied to introduce a new generation of this tool in the engineering world.
S. Sepehri; R. Shirinabadi; N. Hosseini Alaee; E. Moosavi; A. H. Bangian Tabrizi
Abstract
In this research work, a 3D numerical modeling technique is proposed based on the 3D particle flow code in order to investigate the failure mechanism of rock foundations. Two series of footings with different geometries and areas are considered in this work. The failure mechanism obtained is similar ...
Read More
In this research work, a 3D numerical modeling technique is proposed based on the 3D particle flow code in order to investigate the failure mechanism of rock foundations. Two series of footings with different geometries and areas are considered in this work. The failure mechanism obtained is similar to that of the Terzaghi’s but there is a negligible difference in between. Lastly, one equation is presented to calculate the bearing capacity based on the results achieved from the numerical model and the Mohr-Coulomb theory. The sensitivity analyses are performed on the friction angle, cohesion, and footing width. The results obtained are compared with the corresponding results given by the equations given by Terzaghi and Meyerhof. This comparison demonstrates a good agreement between them. In the friction angle sensitive analysis, the amounts of the bearing capacity diagram are very close to Meyerhof’s, which overlap with each other.