Rock Mechanics
Ghorban Khandouzi; Mohammad Hossein Khosravi
Abstract
Granular materials used in engineering structures tend to experience arching under different geotechnical factors. Arching is a factor of load transfer from the destroyed zone to stable areas in these structures. Soil arching plays an important role in stress redistribution, settlement, and load on supports ...
Read More
Granular materials used in engineering structures tend to experience arching under different geotechnical factors. Arching is a factor of load transfer from the destroyed zone to stable areas in these structures. Soil arching plays an important role in stress redistribution, settlement, and load on supports in tunneling. This paper reviews the effect of various parameters on the development of soil arching and formation of expansion and contraction zones around the tunnel. A comprehensive literature review, analysis of new published papers, and investigations were conducted to study the effects of various parameters on soil arching. The results were obtained by studying the formation of shear bands, deformed zones, and their development. The achieved results of investigations show that soil arching and ground deformation around tunnels in sandy grounds are complex phenomena that require careful consideration during tunnel construction. Also the results reveal that despite the arching zone, a loosened zone with non-linear slip surfaces forms above the tunnel. With the onset of tunnel convergence, initial non-linear sliding surfaces appear, and the arching area forms above the tunnel. When tunnel convergence increases, a stable arch forms inside the arching zone, and a de-stressed area as a loosened zone is created under the stable arch. Understanding of soil arching, ground deformation, and the stable arch formed inside the arching zone around tunnels in sandy grounds is very important for the engineers evaluating stress redistribution and load on tunnel supports. Also understanding these issues can help the designers and practitioners make informed decisions during tunnel construction.
Rock Mechanics
M. H. Khosravi; T. Pipatpongsa; J. Takemura; M. Amini
Abstract
A series of physical modeling tests were conducted by means of a beam type geotechnical centrifuge machine in order to investigate the drainage impact on the slope failure mechanism under centrifugal acceleration. Meanwhile, the phenomenon of stress redistribution in undercut slopes and the formation ...
Read More
A series of physical modeling tests were conducted by means of a beam type geotechnical centrifuge machine in order to investigate the drainage impact on the slope failure mechanism under centrifugal acceleration. Meanwhile, the phenomenon of stress redistribution in undercut slopes and the formation of arching effect were studied. For this purpose, a poorly graded sandy soil (Silica sand No. 6) as well as a relatively well-graded sandy soil (Edosaki sand) were used as the modeling materials. The humid modeling material was compacted on a low friction oblique rigid plate simulating the potential slippage plane. The process of undercutting was conducted, while the earth pressure redistribution inside the model was recorded by means of a miniature set of pressure cells. The results obtained showed completely different failure mechanisms for the two different modeling soils. By undercutting the slope, the earth pressure redistributed and the arch action was formed in a slope model made from a well-graded soil leading to a clear arch-shaped failure. However, in using the poorly graded soil, the water was drained out during centrifuge g-up, the modeling material properties changed, and an avalanche failure was observed. Therefore, in selecting a humid compacted soil as the centrifugal modeling material, a well-graded soil is recommended.
