M. Davood Yavari; H. Haeri; V. Sarfarazi; M. Fatehi Marji; H. A. Lazemi
Abstract
Investigating the crack propagation mechanism is of paramount importance in analyzing the failure process of most materials. This process may be exposed during each kind of loading on the materials. In this work, the cracking mechanism in rock-like materials is studied using the numerical methods and ...
Read More
Investigating the crack propagation mechanism is of paramount importance in analyzing the failure process of most materials. This process may be exposed during each kind of loading on the materials. In this work, the cracking mechanism in rock-like materials is studied using the numerical methods and compared with the experimental test results. However, the mechanism of crack growth in brittle materials such as rocks is influenced by different parameters. This research work focuses on the effect of the initial crack angles on the crack growth paths of these materials. Some cubic samples containing pre-existing cracks are tested in compression by considering different flaw orientations. The specimens are made of cement, water, and sand. Moreover, the mentioned process is numerically simulated using three different methods: the finite difference method for discontinuous bodies or discrete element method, the displacement discontinuity method, and the versatile finite element method. The micro-parameters for simulation are gained by the trial-and-error procedure for the discrete element method. Eventually, the crack growth paths observed in the experiments are compared with the numerically simulated models. The results obtained show that these central cracks propagate in two ways, which are dependent on their initial angle. By increasing the initial crack angle to greater than 30° (α > 30°), the wing crack path moves further away from the initial crack, and by decreasing α to smaller than 30° (α < 30°), only the shear cracks are initiated. Therefore, the validity and accuracy of the results are manifested by comparing all the corresponding results obtained by different methods. Based on these results, it can generally be concluded that the strength of the cubic (rock material) specimens increases with increase in the crack angles with respect to the applied loading direction.
Rock Mechanics
S. Ali Madadi; A. Majdi; M. H. Khosravi; A.R. Kargar
Abstract
Fracture mechanics is a vital component involved in studying the exact behavior of rock materials. Detection and assessment of the behavior of rock joints injected by grout plays an important role in numerical modelling in rock mechanic projects. The importance of mechanisms associated with initiation ...
Read More
Fracture mechanics is a vital component involved in studying the exact behavior of rock materials. Detection and assessment of the behavior of rock joints injected by grout plays an important role in numerical modelling in rock mechanic projects. The importance of mechanisms associated with initiation and propagation of cracks due to hydraulic fracturing has led to a considerable interest in investigation and analysis of this phenomenon. In this work, the process of propagation of cracks on the wall of boreholes, drilled in single and bi-material structures, was simulated in ABAQUS software employing the extended finite element method. The energy method was implemented to obtain the stress intensity factor and energy release rate through applying J integral around the crack tip. The method was applied to two rock types, diorite and granite at the Chadormalu iron mine located in the central part of Iran. It was concluded that assuming the same geometry, the possibility of crack propagation at the boundary between two materials was more than the single material medium. Therefore, in dealing with a bi-material medium, if the purpose is to measure the in situ stresses, the measurement should not be performed on the boundary between the two materials.
