Mineral Processing
M. B. Fathi; B. Rezai; E. K. Alamdari; R. D. Alorro
Abstract
The effects of the functional groups and structures of two different resins, weak base/macroporous and strong base/gel type, Purolite A170 and Dowex 21K on the adsorption properties of Re(VII) ions were investigated experimentally and described by the isotherm, kinetic, and thermodynamic modeling. In ...
Read More
The effects of the functional groups and structures of two different resins, weak base/macroporous and strong base/gel type, Purolite A170 and Dowex 21K on the adsorption properties of Re(VII) ions were investigated experimentally and described by the isotherm, kinetic, and thermodynamic modeling. In this regard, four widely used adsorption isotherm models including Langmuir, Freundlich, Temkin, and Dubinin-Radushkevich (D-R) were subjected to the sorption data in order to describe the reactions involved. Evaluating the correlation coefficients showed that the Freundlich and D-R isotherm models provided the best fit. The Langmuir isotherm capacities (qm) indicated that the perrhenate ion (ReO4-) adsorption was higher for the weak base/macroporous type resin rather than the others (166.67 mg/g and 142.86 mg/g, respectively). Moreover, the results of the EDX studies were in agreement with the previous results. Furthermore, the adsorption kinetics was demonstrated through fitting the data into different mechanisms, among which the pseudo-second-order mechanism was found to be successful for both resins; however, in the case of Dowex 21K, the rate of perrhenate ion uptake was more rapid than that for Purolite A170. Evaluation of the thermodynamic parameters also showed that the reaction mechanism was different for each case and that the adsorption of rhenium on Dowex 21K became more feasible with increase in temperature due to negative values for ΔH.
Ali Entezari; Mohammad Karamoozian; M Eskandari Nasab
Abstract
The possibility of selective leaching process was investigated during molybdenite flue dust leaching to recover its rhenium content. The results show that addition of alcohols to water makes the medium less favorable for molybdenum transfer into aqueous phase. On the other hand, addition of small amounts ...
Read More
The possibility of selective leaching process was investigated during molybdenite flue dust leaching to recover its rhenium content. The results show that addition of alcohols to water makes the medium less favorable for molybdenum transfer into aqueous phase. On the other hand, addition of small amounts of alcohols (5-15%) makes a noticeable separation of rhenium over molybdenum, but by increasing the alcohol content recovery of both metals decreases. More than 90% of Re transferred into leach solution but the corresponding amount for Mo was only about 0.5%.
