Rock Mechanics
Vahab Sarfarazi; Hadi Haeri; Mohammad Fatehi Marji; Gholamreza Saeedi; Amir Namdarmanesh
Abstract
In this paper, the effect of variations in the number and area of the rock bridges on the non-persistent discontinuities is investigated. In this regard, blocks containing rock bridges and joints with dimensions of 15 cm * 15 cm * 15 cm are prepared from plaster. The available rock bridges that have ...
Read More
In this paper, the effect of variations in the number and area of the rock bridges on the non-persistent discontinuities is investigated. In this regard, blocks containing rock bridges and joints with dimensions of 15 cm * 15 cm * 15 cm are prepared from plaster. The available rock bridges that have occupied 0.2, 0.4, and 0.6 of the shear surface show latitudinal extension along the shear surface. There are variations in the number and extension of the rock bridges in the fixed area. For each of the samples, tests are performed on three blocks of the same material, by putting it under various direct normal stresses. Normal stresses were 3.33, 5.55, 7.77 kg/cm2. Also the obtained shear strength by laboratory tests was compared with the outputs of Jenning's criterion and Guo and Qi's criterion to determine the accuracy of these criteria for predicting the shear strength of non-persistent joints. The results show that the tensile crack started in the rock bridge under normal stress of 3.33 kg/cm2. Mixed-mode tensile shear cracks were propagated in the rock bridge under a normal stress of 5.55 kg/cm2, while a pure shear crack developed in the rock bridge under a normal stress of 7.77 kg/cm2. With the increase of normal stress, the number of microfractures increased. The variance in the number of rock bridges in the fixed area of the rock bridge does not affect the friction angle along the shear surface. Furthermore, the cohesion along the shear surface shows a small decrease with the increasing number of rock bridges. Also by the increase in the area of rock bridges, the friction angle along the shear surface remains constant, while at the same time, there is an almost linear increase in cohesion. Guo and Qi's criterion predicts the shear strength of the non-persistent joint exactly close to the shear strength of the physical samples.
V. Sarfarazi; A. Tabaroei
Abstract
In this work, the effect of rock bolt angle on the shear behavior of Rock Bridges is investigated using the particle flow code in two dimensions (PFC2D) for three different Rock Bridge lengths. Firstly, the calibration of PF2D is performed to reproduce the gypsum sample. Then the numerical models with ...
Read More
In this work, the effect of rock bolt angle on the shear behavior of Rock Bridges is investigated using the particle flow code in two dimensions (PFC2D) for three different Rock Bridge lengths. Firstly, the calibration of PF2D is performed to reproduce the gypsum sample. Then the numerical models with the dimensions of 100 mm * 100 mm are prepared. The Rock Bridge is created in the middle of the model by removal of the narrow bands of discs from it. The uniaxial compressive strength of the Rock Bridge is 7.4 MPa. The Rock Bridge lengths are 30 mm, 50 mm, and 70 mm. The rock bolt is calibrated by a parallel bond. The tensile strength of the simulated rock bolt is 360 MPa.One rock bolt is implemented in the Rock Bridge. The rock bolt angles related to the horizontal axis are the changes from 0 to 75 degrees. Totally, 18 models are prepared. The shear test condition is added to the models. The normal stress is fixed at 2 MPa, and the shear load is added to the model till failure occurs. The results obtained show that in a fixed rock bolt angle, the tensile crack initiates from the joint tip and propagates parallel to the shear loading axis till coalescence to rock bolt. In a constant Rock Bridge length, the shear strength decreases with increase in the rock bolt angle. The highest shear strength occurs when the rock bolt angle is 0°.