TY - JOUR ID - 2150 TI - Determining an Appropriate range for the Number of Cuboid Lifters in Ball Mills using DEM JO - Journal of Mining and Environment JA - JME LA - en SN - 2251-8592 AU - Jahani Chegeni, M. AU - Kolahi, S. AD - Faculty of Mining, Petroleum and Geophysics Engineering, Shahrood University of Technology, Shahrood, Iran Y1 - 2021 PY - 2021 VL - 12 IS - 3 SP - 845 EP - 862 KW - DEM simulation KW - ball mills KW - Number of Lifters KW - Head height (HH) KW - Impact zone length (IZL) DO - 10.22044/jme.2021.11052.2081 N2 - The number of lifters in the liner of ball mills and the mill rotation speed are among the most significant factors affecting the behavior of grinding charge (balls) and their motion trajectory, and consequently, the comminution mechanism in these mills. In this research, in order to find a suitable range for the number of lifters in the liner of ball mills, the DEM method is utilized. Initially, a pilot-scale ball mill with dimensions of 2.0 m × 1.11 m without any lifter is simulated. Afterwards, by adding, respectively, 1, 2, 4, 8, 16, 20, 26, 30, and 32 cuboid lifter(s) with dimensions of 2 m × 5 cm × 5 cm, nine other separate simulations are performed. The influences of the number of cuboid lifters on the two new factors introduced here, namely ‘head height’ (HH) and ‘impact zone length’ (IZL) at various mill speeds, that is, 70% and 80% of its critical speed (CS) are investigated. The results indicate that in order to find a suitable range for the number of lifters in the liner of ball mills, it is necessary to consider these two parameters simultaneously as the criteria for selecting the appropriate range, That is, liners that simultaneously produce both a higher HH and a greater IZL are more suitable for use in the industry. The results also demonstrate that the suitable range for the number of cuboid lifters in the liner of ball mills is between 16 and 32, which field research on the ball mills of three different plants in the industry confirms the accuracy of the results obtained in this research. Unlike the previous research works, it has now been shown that the number of ball mill lifters does not only depend on the diameter of the mill but also depends on the width, height, angle of the lifter, and generally on the type of lifter. UR - https://jme.shahroodut.ac.ir/article_2150.html L1 - https://jme.shahroodut.ac.ir/article_2150_d1c385fd31ad2e1c6960e80377279625.pdf ER -