Document Type : Original Research Paper

Authors

Department of Civil Engineering, Malaviya National Institute of Technology, Jaipur, 302017, India

Abstract

The present study aims to assess the utility of construction and demolition (C&D) waste, specifically recycled concrete aggregates (RCA) and recycled brick aggregates (RBA), as fill materials in highway embankments. The assessment of slope stability is crucial in determining the suitability of any material for embankment fill. GeoStudio software is employed in this study for slope stability assessment of 12 models with LS, RCA, RBA, and their blends as embankment fill materials. The embankment configuration is designed to represent a six-lane highway (carriageway width = 13 m, adhering to IRC: 36 standards), featuring varying slope elevations (3 m, 6 m, and 9 m) and diverse horizontal to vertical slope ratios (H:V = 2:1, 1:1, 1:2, and 1:3). The Morgenstern-Price method is employed to analyze slope stability and determine factor of safety (FOS) values. The study highlights the impact of slope heights, slope ratios, and fill materials (RCA, RBA, LS, and their blends) on FOS values in embankment models. Incorporating RCA or RBA in LS significantly boosts embankment FOS, exceeding stability expectations beyond 45˚ slope angles, potentially reducing costs and required area in construction projects. The incorporation of RCA/RBA into LS increases the FOS values to a range of 1.38 to 5.91, indicating very stable slopes for highway embankments. Based on the findings, replacing LS with RCA or RBA in embankment fill can enhance environmental sustainability and economic efficiency. However, these slope stability results apply specifically to C&D waste with similar composition, grain size, geotechnical properties, and embankment conditions.

Keywords

Main Subjects

  • Junaid, M., Abdullah, R. A., Sa’ari, R., Rehman, H., Shah, K. S., Ullah, R., ... & Zainuddin, N. E. (2022). Quantification of Rock Mass Condition Based on Fracture Frequency Using Unmanned Aerial Vehicle Survey for Slope Stability Assessment. Journal of the Indian Society of Remote Sensing, 50(11), 2041-2054.
  • Junaid, M., Abdullah, R. A., Saa'ri, R., & Alel, M. N. A. (2022). An expeditious approach for slope stability assessment using integrated 2D electrical resistivity tomography and unmanned aerial vehicle survey. Journal of Applied Geophysics, 205, 104778.
  • Junaid, M., Abdullah, R. A., Sa’ari, R., Shah, K. S., & Ullah, R. (2023). A comparative study of the influence of volumetric joint counts (Jv) and resistivity on rock quality designation (RQD) using multiple linear regression. Pure and Applied Geophysics, 180(6), 2351-2368.
  • Bishop, A. W. (1955). The use of the slip circle in the stability analysis of slopes. Geotechnique 5(1), 7-17.
  • Zhao, Y., Tong, Z. Y., Lü, Q. (2014). Slope stability analysis using slice-wise factor of safety. Mathematical Problems in Engineering, 1-7.
  • Verma, D., Thareja, R., Kainthola, A., Singh, T.N. (2011). Evaluation of open pit mine slope stability analysis. International Journal of Earth Sciences and Engineering 4(4), 590-600.
  • Jampani H., Bhupathi N. (2017). Stability analysis of slope with different soil types and its stabilization techniques. Proceeding of Indian Geotechnical Conference (GeoNEst), pp. 1-4.
  • Devi D. D. L., Anbalagan R. (2017). Study on slope stability of earthen dams by using GeoStudio software. International Journal of Advance Research, Ideas and Innovations in Technology 3(6), 408-14.
  • Griffiths, D.V., Lane, P.A. (1999). Slope stability analysis by finite elements. Geotechnique 49(3), 387-403.
  • Al-Labban, S. N. Y. (2007). Seepage analysis of earth dams by finite elements. The College of Engineering of University of Kufa, Iraq.
  • Pham, H.T., Oo, H.Z., Jing, C. (2013). Stability of slope and seepage analysis in earth dam using numerical finite element model. Study of Civil Engineering and Architecture (SCEA) 2(4), 104-108.
  • Athani, S.S., Solanki, C.H., Dodagoudar, G.R. (2015). Seepage and stability analyses of earth dam using finite element method. Aquatic Procedia, 4, 876-883.
  • Zhang, R., Zhao, J., & Wang, G. (2016). Stability analysis of anchored soil slope based on finite element limit equilibrium method. Mathematical Problems in Engineering, 2016(1), 7857490.
  • Siddque, T., & Pradhan, S. P. (2018). Stability and sensitivity analysis of Himalayan road cut debris slopes: an investigation along NH-58, India. Natural Hazards, 93, 577-600.
  • Nian, T. K., Chen, G. Q., Luan, M. T., Yang, Q., & Zheng, D. F. (2008). Limit analysis of the stability of slopes reinforced with piles against landslide in nonhomogeneous and anisotropic soils. Canadian Geotechnical Journal, 45(8), 1092-1103.
  • Mishal, U. R., Khayyun, T. S. (2018). Stability analysis of an earth dam using GEO-SLOPE model under different soil conditions. Engineering and Technology Journal 36(5A), 523-532.
  • Dewedree, S., Jusoh, S. N. (2019). Slope stability analysis under different soil nailing parameters using the SLOPE/W software. In Journal of Physics: Conference Series, vol. 1174, no. 1, p. 012008. IOP Publishing.
  • Nalgire, T., Dahale, P. P., Mehta, A. A., Hiwase, P. D. (2020). Slope Stability Analysis by GeoSlope. , 10, 71-75.
  • Malik, M. K., Karim, I. R. (2020). Seepage and slope stability analysis of Haditha Dam using Geo-Studio Software. In IOP conference series: materials science and engineering, vol. 928, no. 2, p. 022074). IOP Publishing.
  • Tan, Y. L., Cao, J. J., Xiang, W. X., Xu, W. Z., Tian, J. W., Gou, Y. (2023). Slope stability analysis of saturated–unsaturated based on the GEO-studio: a case study of Xinchang slope in Lanping County, Yunnan Province, China. Environmental Earth Sciences 82(13), 322.
  • Al-Homoud, A. S., Tal, A. B., & Taqieddin, S. A. (1997). A comparative study of slope stability methods and mitigative design of a highway embankment landslide with a potential for deep seated sliding. Engineering geology, 47(1-2), 157-173.
  • Kumar, A., Sharma, R. K., & Mehta, B. S. (2020). Slope stability analysis and mitigation measures for selected landslide sites along NH-205 in Himachal Pradesh, India. Journal of Earth System Science, 129(1), 135.
  • Subramanian, S. S., Ishikawa, T., & Tokoro, T. (2017). Stability assessment approach for soil slopes in seasonal cold regions. Engineering geology, 221, 154-169.
  • Touahamia, M., Sivakumar, V., McKelvey, D. (2002). Shear strength of reinforced-recycled material. Construction and Building Materials 16(6), 331-339.
  • Disfani, M. M., Arulrajah, A., Bo, M. W., Hankour, R. J. W. M. (2011). Recycled crushed glass in road work applications. Waste Management 31(11), 2341-2351.
  • Arulrajah, A., Rahman, M. A., Piratheepan, J., Bo, M. W., Imteaz, M. A. (2013). Interface shear strength testing of geogrid-reinforced construction and demolition materials. Advances in Civil Engineering Materials 2(1), 189-200.
  • Santos, E. C., Palmeira, E. M., Bathurst, R. J. (2013). Behaviour of a geogrid reinforced wall built with recycled construction and demolition waste backfill on a collapsible foundation. Geotextiles and Geomembranes 39, 9-19.
  • Vieira, C. S., Pereira, P. M. (2018). Use of Mixed Construction and Demolition Recycled Materials in Geosynthetic Reinforced Embankments. Indian Geotechnical Journal 48(2), 279-292.
  • Zhang, J., Gu, F., Zhang, Y. (2019). Use of building-related construction and demolition wastes in highway embankment: laboratory and field evaluations. Journal of Cleaner Production 230, 1051-1060.
  • Konstantopoulou, G., Spanou, N. (2013). Stability analysis of construction and demolition waste (CDW) deposits in theabandoned quarry of Profitis Ilias, Kozani, Greece. Bulletin of the Geological Society of Greece 47(4), 1706-1714.
  • Yang, H., Xia, J., Thompson, J. R., Flower, R. J. (2017). Urban construction and demolition waste and landfill failure in Shenzhen, China. Waste management 63, 393-396.
  • Kumar, A. R., Bhushan, J. S. (2020). Slope Stability Analysis of Recycled Concrete Fine Aggregate Stabilized and Blended Soils. International Journal of Innovative Technology and Exploring Engineering 9(5), 991-994.
  • Li, L., Sheng, H., Xiao, H., Zhou, X., Li, W., Liu, Y. (2022). Mechanical behavior of reinforced embankment with different recycling waste fillers. KSCE Journal of Civil Engineering 26(8), 3251-3264.
  • IRC: 75 (2015). Guidelines for the Design of High Embankments. Published by Indian Roads Congress, New Delhi, India.
  • Fellenius, W. (1936). Calculation of the stability of earth dams. In Proc. of the second congress on large dams (Vol. 4, pp. 445-463).
  • Janbu, N. (1973). Slope Stability Computations. Embankment Dam Engineering, Casagrande Volume, pp. 47‐86.
  • Morgenstern, N. U., & Price, V. E. (1965). The analysis of the stability of general slip surfaces. Geotechnique, 15(1), 79-93.
  • Spencer, E. (1967). A method of analysis of the stability of embankments assuming parallel inter-slice forces. Geotechnique, 17(1), 11-26.
  • Sarma, S. K. (1973). Stability analysis of embankments and slopes. Geotechnique, 23(3), 423-433.
  • Sharma, A., & Shrivastava, N. (2024). Settlement Behavior of Recycled Construction and Demolition Waste Aggregates with Sandy Soil by Performing Laboratory Model Plate Load Test. Transportation Infrastructure Geotechnology, 11(1), 303-326.
  • IRC: 36 (1970). Recommended practice for the construction of embankments for road works. Indian Road Congress, New Delhi.
  • IS: 1893 (Part I) (2002). Criteria for Earthquake Resistant Design of Structures—General Provision And Buildings (Fifth Revision), Bureau of Indian Standards, New Delhi, India.
  • Sharma, A., & Shrivastava, N. (2023). Geotechnical Characterization of Construction and Demolition Waste Material Blended with Sandy Soil. International Journal of Geosynthetics and Ground Engineering, 9(4), 43.
  • Ikeagwuani, C. C., & Nwonu, D. C. (2023). Stability Analysis and Prediction of Coconut Shell Ash Modified Expansive Soil as Road Embankment Material. Transportation infrastructure geotechnology, 10(2), 329-358.
  • Jakka, R. S., Ramana, G. V., & Datta, M. (2011). Seismic slope stability of embankments constructed with pond ash. Geotechnical and Geological Engineering, 29, 821-835.
  • Amena, S. (2022). Analysis of the Stability of Reinforced Plastic Waste Treated Clay as Embankment Fill on Soft Soils. Advances in Civil Engineering, 2022(1), 1831970.
  • Somantri, A. K., & Febriansya, A. (2019, December). The effect of EPS addition to soil stabilized with fly ash as lightweight fill materials for embankment construction. In Journal of Physics: Conference Series (Vol. 1364, No. 1, p. 012077). IOP Publishing.
  • Baker, R. (2003). A second look at Taylor’s stability chart. Journal of Geotechnical and Geoenvironmental Engineering, 129(12), 1102-1108.