B. Alipenhani; A. Majdi; H. Bakhshandeh Amnieh
Abstract
The present work aims at implementing Response Surface Methodology (RSM) in order to generate a statistical model for Minimum Required Caving Span (MRCS) and estimate both the individual and mutual effects of the rock mass parameters on rock mass cavability. The adequate required data is obtained from ...
Read More
The present work aims at implementing Response Surface Methodology (RSM) in order to generate a statistical model for Minimum Required Caving Span (MRCS) and estimate both the individual and mutual effects of the rock mass parameters on rock mass cavability. The adequate required data is obtained from the result of numerical modeling. In this work, various arrays of numerical simulations (480 models) are carried out using the UDEC software in order to study the rock mass cavability thoroughly. The effect of each individual parameter and their mutual effect on MRCS are investigated by means of ANOVA. ANOVA indicates that all the chosen parameters (depth, dip of the joint, number of joints, angle of friction of the joint surface, and joint spacing) highly affect MRCS. In other words, the results of ANOVA are in high agreement with the results of the conventional sensitivity analysis. Moreover, a combination of joint spacing and joint inclination has the highest mutual effect on MRCS, and a combination of undercut depth and joint spacing has the lowest effect on MRCS.
Omid Saeidi; Ahmad Ramezanzadeh; Farhang Sereshki; Seyed Mohammad Esmaeil Jalali
Abstract
This study aims at presenting a numerical model for predicting grout flow and penetration length into the jointed rock mass using Universal Distinct Element Code (UDEC). The numerical model is validated using practical data and analytical method for grouting process. Input data for the modeling, including ...
Read More
This study aims at presenting a numerical model for predicting grout flow and penetration length into the jointed rock mass using Universal Distinct Element Code (UDEC). The numerical model is validated using practical data and analytical method for grouting process. Input data for the modeling, including geomechanical parameters along with grout properties, were obtained from a case study. The effect of rock mass properties such as joint hydraulic aperture, spacing, trace length, orientation and grout properties as yield stress and water to cement, w/c ratio was considered on grout flow rate and penetration length. To illustrate the effect of aforementioned properties, models were constructed with dimensions of 40×20m. A vertical borehole with diameter of 60mm and 10m depth was drilled in a jointed rock media. The results were in a good agreement with analytical method. It was observed that by increasing joint hydraulic aperture, grouting flow increases using a power law function. The optimum grout penetration observed with joint sets intersection of 40°-60° as experienced in practice. With an increase in joint spacing grout penetration increases around borehole when spacing exceeds two meters it decreases, gradually.
