Exploration
Irshad Khan; Afayou Afayou; Naeem Abbas; Asghar Khan; Numan Alam; Kausar Sultan Shah
Abstract
The study utilizes the Limit Equilibrium Method (LEM) to investigate slope movements. These movements were initially generated by construction activities at the slope's base, and subsequent events were driven by seismic activities, as the study studied area lies within the Main Karakoram Thrust (MKT) ...
Read More
The study utilizes the Limit Equilibrium Method (LEM) to investigate slope movements. These movements were initially generated by construction activities at the slope's base, and subsequent events were driven by seismic activities, as the study studied area lies within the Main Karakoram Thrust (MKT) and Main Mantle Thrust (MMT) zones. Soil samples, characterized by a moisture content of 13% and a dry unit weight of 18.14 kN/m³ were analyzed. The study revealed that an increase in saturation caused by rainwater infiltration, resulted in a reduction in unconfined compression strength, decreasing from 712 kPa to 349 kPa. The shear strength and deformation parameters (cohesion, angle of internal friction, and deformation modulus) were also examined with varied degrees of saturation. The results revealed a decrease in these parameters as the percentage of saturation increased from 30% to 90%. The slope stability study revealed that the Factor of Safety (FOS) reduced from 1.85 to 0.86 as the saturation of the material raised from 30% to 90%. To assess the influence of unit weight, cohesion, and angle of internal friction on the FOS, multiple cases were considered. The analysis revealed that the FOS increased with higher cohesion and angle of internal friction, while an increase in unit weight resulted in a lower factor of safety. Furthermore, stability of the slope was evaluated by modifying the slope geometry such as lowering the height. According to the GeoStudio investigation, the slope remained steady even at saturation levels exceeding 80%.
Rock Mechanics
M. H. Askarbioki; F. Kargaran Bafghi; M. Mokhtari; M. Khaleghi
Abstract
Oil leakage causes soil contamination and induces changes in the physical and mechanical properties of soils. In areas contaminated with oil products such as gasoline, the implementation of civilian operations requires determination and prediction of soil behavior in the existing conditions. In this ...
Read More
Oil leakage causes soil contamination and induces changes in the physical and mechanical properties of soils. In areas contaminated with oil products such as gasoline, the implementation of civilian operations requires determination and prediction of soil behavior in the existing conditions. In this research work, the effect of oil contamination by gasoline obtained from the National Oil Company in the Yazd Province is considered to investigate the effect of contaminants on the geotechnical properties of fine-grained sand. In order to examine the geotechnical characteristics of contaminated soil, compaction, undrained triaxial (CU), and consolidation tests are conducted. The tests are carried out on the samples of clean soil and contaminated soil with 1, 3, and 5% gasoline. The results obtained show that added gasoline reduces the optimum moisture content and increases the maximum dry density. In addition, based on the results of the triaxial test, the amount of friction angle and the cohesion of clay sand decrease by 21% and 14% with increasing contamination up to 5%, respectively, compared to the clean soil sample. Furthermore, adding gasoline significantly increases the compressibility and compression index.
